A Classic Slider Card

Stampin' Up! Products

• Night of Navy cardstock
  
• Card base measures 5 1/4" x 4 1/4"
• Note that the width of the card base is less than an A2 card; this is to accommodate the tag sticking out
• Bashful Blue cardstock
• Scrap for stamped image
• Finished banner measures 2 3/4" x 1"
• Pumpkin Pie cardstock
• Card layer measures 5" x 4"
• Finished tag measures 4 7/8" x 2"
• Stamp "To A Classic" 1" from bottom edge
• Travel Journal Designer Series Paper
• Card layer measures 4 3/4" x 3 3/4"
• Draw pencil line on back of this piece 3/4" from bottom and 3/4" on each side
• Using Word Window punch, line bottom edge of punch cut line to pencil line and punch 3/4" in from one side and 3/4" in from other side
• Guy Greetings stamp set
• Night of Navy ink
• Night of Navy 1/4" grosgrain ribbon
• Banner Triple, Scallop Tag Topper and Word Window punches
• Candy Dot
• Dimensional
• Foam Tape

Putting together card

• Prepare cardstock pieces following information above

• Turn over patterned cardstock and encase tag using foam tape as indicated in this picture

• Remove liner and attach patterned cardstock to front of card
• Slide in tag, butting up against foam tape

• Place glue dot on penny and attach to stamped car image
• Flip over and place a Dimensional on the penny

• Remove liner off Dimensional and place on card, allowing Dimensional to only stick to tag

*I did have to make a new tag because I didn't stamp the "To A Classic" sentiment far enough to the left.