Z Front Panel Fun Fold Card

If you like the adorable Ladybug, you WILL LOVE my HELLO LADYBUG FUN FOLD SERIES. In this one tutorial you will make TWENTY different fun folds using the Hello Ladybug stamp set and Ladybug Builder punch. Click HERE for more information.

Stampin' Up! Products

• Real Red cardstock
• Card base measures 8 1/2" x 5 1/2"
• Score at 2 1/8" and 4 1/4"
• Card layer (inside) measures 5/8" x 5 1/8"
• Scrap for ladybug and scallop circle
• Basic Black cardstock
• Card layers measure 4" x 5 1/4" (cut two)
• One of these is adhered to the left panel only
• Refer to diagram available below
• Scrap for ladybug
• Basic White cardstock
• Card layer (inside) measures 3 7/8" x 5 1/8"
• Scrap for sentiment circle
• Petal Passion Designer Series Paper
• Card panel layer measures 3 7/8" x 5 1/8"
• See tip below
• Card layer (inside) measures 1/2" x 5 1/8"
• Dahlia Days and Hello Ladybug stamp sets
• Memento Tuxedo Black and Real Red inks
• Layering Circle dies
• Ladybug Builder punch
• Rhinestones
• Dimensionals

The diagram with measurements for the card is FREE, please FOLLOW each step.  These steps must be followed completely. Any email request without FIRST posting a comment on this blog post will be discarded.

1. Follow my blog
2. Post a comment on my blog. Comment link is at the end of this post.
3. EMAIL me asking for the Z Front Panel Fun Fold. If you post a "anonymous" comment on my blog you have to also state in the email that you commented. When you post anonymously I CANNOT tie it back to an email address.
4. DO NOT POST YOUR EMAIL ADDRESS ON MY BLOG - Spam bots will find it.

TIP

Cut the width of your 12" x 12" to 4" x 12" then cut a piece 5 1/8" x 3 7/8". If you are only making one, the left over piece width will be 4" which is a commonly used width.