Monday, February 27, 2023

It's My Party Panda Series - Card #27


Stampin' Up! Products
  • Basic Black cardstock
    • Card base measures 5 1/4" x 4"
  • Basic White cardstock
    • Card layer (inside) measures 5 1/4" x 4"
    • Scrap for panda
  • Crushed Curry cardstock
    • Finished banner measures 1 3/4" x 3/8"
  • Melon Mambo cardstock
    • Card layer measures 5 1/4" x 4"
    • Card layer (inside) measures 5/8" x 4"
  • Mint Macaron cardstock
    • Strip measures 5 3/4" x 3/8"
      • Crimp and flatten
  • White Full Sheet Labels 
    • Begin with a piece 5 1/2" x 2 1/2" 
      • After attaching strips, run it through a Big Shot with some cardstock. This gives a more secure bond to the label sheet
      • Mark the center of your design at 2 3/4"
        • Find the center of the 5 1/2" wide - which is 2 3/4". Trim down from each side by 3 1/16" 
      • Rough up using a nail file the back side of this label for better adhesion before attaching the cardstock
  • It's My Party Designer Series Paper
    • Strips measure 4 3/4" x 1", cut diagonally
      • If  you have a directional pattern you will only get 1 strip out of this piece
        • I traced one strip to get the smaller pieces needed at the outside edges
    • Card layer (inside) measures 1/2" x 4"
  • Party Pandas stamp set
  • Memento Tuxedo Black ink
  • Stampin' Blends alcohol markers
  • Wink of Stella Clear
  • Banner Pick a Punch
  • Gold rhinestones
  • Dimensionals

No comments:

Post a Comment