It's My Party Panda Series - Card #11

Stampin' Up! Products

• Melon Mambo cardstock
• Card base measures 8 1/2" x 5 1/2"
• Scored at 4 1/4"
• Card layer (inside) measures 4" x 5/8"
• Acetate (optional)
• Card layer (inside front) measures 4" x 5 1/4"
• 
  Basic White cardstock
• Card layer (inside) measures 4" x 5 1/4"
  
• Scrap for pandas
• It's My Party Designer Series Paper
• Card layer measures 4" x 5 1/4"
• Card layer (inside) measures 4" x 1/2"
• Party Pandas stamp sets
• Memento Tuxedo Black ink
• Stampin' Blends alcohol markers
• Circle dies
• Largest approximately 3"
• Smallest approximately 2 7/8"
• Wink of Stella Clear
• Party hats
• Optional enamel dots (see note)

1. Die cut 4" x 5 1/4" DSP with largest circle. Keep DSP circle for Card #12
2. Apply glue to DSP and attach card base.
3. Place smaller die on the card front, centering inside the previous die cut circle. Open card and die cut. Keep circle for Step 6.
4. Glue 4" x 1/2" DSP to 4" x 5 /8" MM card layer.
5. Glue to the bottom edge of the 4" x 5 1/4" BB card layer. Attach to the inside of the card
6. Close card and glue the die cut circle piece to the card, gluing it to the BB card layer inside
7. Optional - Place acetate to the inside of the card (right half), Place glue dots in the four corners of the inside left side of the card. Gently close card 
8. The "Love You" panda is attached to the inside of the card

Step 1

Step 2

Step 3

Final product

Note - In case you are considering adding enamel dots or rhinestones, they will not stick to the acetate. Do not place them on the inside as they will leave an impression on the acetate.

This card could easily be converted to a shaker card.